![]() Or coat cardboard with fiberglass to pull off these ironman suits. A lot of people just melt PLA/styrene sheets. We’re probably in line with shapeways or slightly more but yeah… makerbot first. This thing has no detail so its doable on a makerbot. Gesso/bondo the surface if u want (unnecessary really… u might wind up with hairline fractures later). Then sand it flat and do a little bit of fiberglass and resin brushing and sanding to smooth it down. Printing on makerbot wouldn’t cost u more than a couple hundred bucks or so if u did it on someone elses machines. ![]() It’s too expensive for a halloween oneoff to do it as a fineart piece. Yah do that one on a makerbot replicator or something. Hope you’re still printing! I just sent you an email regarding an Ironman mask!!
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |